Super bridge transfers: five checks before you move crypto

Before you move crypto through a super bridge, check five things: the chains, token, address, amount and route. A bridge lets you send value from one blockchain to another, but the two networks do not share one transaction record or one set of rules.

If you need to move an asset and swap it in the same flow, use super bridge, a service for bridging and swapping crypto across blockchains. First, decide which asset you want to send and what you need to receive; that choice sets the route you need to review.

What does a super bridge do?

A super bridge connects a transaction on one blockchain with an outcome on another. Depending on the route, the bridge may use locked assets, newly issued representations, or available liquidity to make that happen.

A swap adds another action: the asset you send can be exchanged for a different one as it crosses networks. That can save you from arranging the transfer and trade separately, but it also means you should check both the destination asset and the bridge route before approving anything.

Which chains and tokens should you check?

Check the source and destination networks first. The same token name can refer to different assets on different chains, and a token sent to an incompatible network or address may not arrive where you expect.

Then confirm the exact token on each side. A native asset and a wrapped version can share a familiar name while representing different claims or operating under different contract addresses. For a swap, check that the asset you receive is the one you intend to hold.

What five checks should you make before moving crypto?

Review these details before you sign. The first four checks establish what is moving and where; the fifth checks whether the route’s expected result suits you.

• 1. Chains: Confirm the sending network and the destination network. Similar network names are easy to mistake.
• 2. Token: Match the asset you are sending and the asset you expect to receive, including whether either is a wrapped version.
• 3. Address: Check the destination address carefully and make sure your wallet can use the destination network.
• 4. Amount and gas: Confirm the amount, and leave enough of the source network’s native asset to pay for the transaction.

5. Route and output: Review the route and the estimated amount to receive before confirming. Swaps can change the final amount as prices move, so consider any displayed minimum output or slippage setting; do not assume the estimate is a guaranteed result.

What happens after you confirm a bridge transfer?

Your wallet first submits a transaction to the source network. The bridge route then has to complete its part on the destination network, so a source-side confirmation alone does not prove the receiving asset has arrived.

Keep the transaction record and check for the expected asset on the destination chain. If the source transaction is confirmed but the destination result is still pending, wait for the route to finish before trying to send the amount again.

The practical rule is simple: verify the five checks before signing, then verify the destination after the transfer. Watch the status of the source transaction and the destination credit; the transfer is complete when the intended asset appears on the intended network.